Power Factor Controllers

HomePower Factor Controllers

Our Partners > Technologic > Power Factor Controllers

Power Factor Controllers

View complete profile here..
  • With Display of PF, Voltage, KVAR, Harmonics %, Panel Temperature and Alarms
  • With Intelligent Alarms for Harmonic Overcurrent, Overvoltage, over temperature & low PF warning.

VARACTOR Series650

Size: 144 x 144 x 50mm

Model:V650/6       (6 – Steps)

Model:V650/12     (12 – Steps)

VARACTOR Series450

Size: 96 x 96 x 50 mm

Model:V450/6       (6 – Steps)

Main Features of Varactor Series 450 & 650:

  • 3 Digit LED Display
  • Powerful Micro Processor based operation
  • Automatic CT Polarity Correction(K&L)
  • Automatic C/K adjustment
  • Gives Multiple Readings suchas: Power Factor, System Voltage, Required KVAR, Harmonic current over load, temperature inside PF Panel, Alarm parameter and value
  • Intelligent Alarm Functions: Over-Voltage, Over Current (Harmonics) Over-Temperature, Low PF Warning
  • Individual Alarm programming & dis-enable
  • Three operating modes: Auto, Man1, Man2 (Set at Auto Mode for regularoperation)
  • Low voltage release: de-energizes the output relays whenever mains failures exceeds for 20ms.
  • High Voltage release: Switches off the capacitor banks incase of temporary phenomena connected with faults generating overvoltage with a higher frequency than mains.

TechnicalSpecifications:

  • Power supply: 230 to 240V OR 115 to 120V ± 10%50/60Hz
  • Voltage input for measurement: 100 to 690V(RMS)
  • Frequency: 50/60 Hz (self-determined)
  • Current input: 5A via CT…5/5A to 12000/5A (Settable)
  • C/K adjustment: Automatic adjustment
  • Switching Interval : (programmable): 2 to 250 sec
  • Switching Sequence: Universal (Selfadapting)
  • Enclosure: Self Extinguishing Plastic (UL94VO).

VARACTORSeries170               

Size: 96 x 48mm

Model: V170/4 (4–Steps)

Main Features:

  • Micro process oroperation
  • Self-Programming (no field set-up required) Automatic recognition of CT primary value
  • Automatic correction of CT wiring errors (phase & orientation) Automatic C/K ratio setting correction
  • No-volt & Low-signal release
  • Plug-in terminal board

Technical Specifications:

  • Voltage Input & Power Supply: 400 ~ 415 V ±10%
  • Current input: 5A via external./5ACT
  • Outputs (steps) 4
  • Switching Sequence: Universal (self-adapting)
  • Protection degree IP54 front panel – IP 20 rear panel
  • Size (DIN43700) 96 x 48 x70mm

Our Partners